![]() Rear view of IP-video camera DS-2CD2420F-I After resetting, the cameras were still not detected on the local network and could not be connected to the TFTP server. However, no external manifestations of the successful reset will be seen. 2) when the camera power is off, press and hold the button “WPS/RST” for 15 seconds, then holding the button “WPS/RST” pressed, turn on the power and hold the button pressed for another 15 seconds. The video camera was also reset to the factory settings by pressing the button “WPS/RST” on the back of the camera (Fig. The actions according to the instructions on replacing/updating firmware via the TFTP server offered on various sites were unsuccessful either – it was impossible to connect the cameras to the TFTP server. The attempts of applying standard IP-addresses were unsuccessful. The network video camera belongs to the series DS-2CD2X22F-IS, platform R2, matrix 2 MP (this information as well as the relevant firmware can be found on the manufacturer’s official website). ![]() Even their MAC-addresses were not detected in the local network. I happened to get two new IP-video cameras Hikvision DS-2CD2420F-I, which were not detected in the IP local network as well as by the network scanner SADP (the utility is available to download on the Hikvision Company’s website). IP- video camera Hikvision DS-2CD2420F-I.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |